The mouse is not detected when Super Zentris is run in DOS.CAUSEYou need to load a special software driver from your mouse manufacturer in order to allow DOS programs to access your mouse. If this driver is not loaded and is not part of your operating system, Super Zentris and other DOS programs cannot access the mouse. RESOLUTIONYou need to load your DOS mouse driver. On most systems, this will be as simple as typing “MOUSE” at your DOS prompt. If you need a copy of the current DOS mouse driver for your mouse, try one of the links below.
Once you download the one of the installation programs above, run it to begin the installation process. If you require additional assistance, contact your mouse manufacturer to learn the procedure for your particular mouse.
This article was last reviewed on 11 May 2000.
| Notes Last reviewed: If you have a problem that you cannot resolve through our Support section, please write to Zensoft Customer Support. Important Note: If you write to us because your issue is not listed on our web site, that means your problem is not a common one. Therefore, we need as much detail as you can give us. Be as thorough as possible in describing the problem so that we are able to help you as quickly as possible. | |||
| ||||




